/**
  @page SysTick_Example SysTick Configuration example
  
  @verbatim
  ******************** (C) COPYRIGHT 2015 STMicroelectronics *******************
  * @file    SysTick/SysTick_Example/readme.txt 
  * @author  MCD Application Team
  * @version V1.1.3
  * @date    15-December-2021
  * @brief   Description of the SysTick Configuration example.
  ******************************************************************************
  *
  * Copyright (c) 2015 STMicroelectronics.
  * All rights reserved.
  *
  * This software is licensed under terms that can be found in the LICENSE file
  * in the root directory of this software component.
  * If no LICENSE file comes with this software, it is provided AS-IS.
  *
  ******************************************************************************
  @endverbatim

@par Example Description 

This example shows how to configure the SysTick to generate a time base equal to
1 ms. The system clock is set to 72 MHz, the SysTick is clocked by the AHB clock
(HCLK).

A "Delay" function is implemented based on the SysTick end-of-count event.
Four LEDs are toggled with a timing defined by the Delay function.
 

@par Directory contents 

  - SysTick/SysTick_Example/stm32f30x_conf.h    Library Configuration file
  - SysTick/SysTick_Example/stm32f30x_it.c      Interrupt handlers
  - SysTick/SysTick_Example/stm32f30x_it.h      Interrupt handlers header file
  - SysTick/SysTick_Example/main.c              Main program
  - SysTick/SysTick_Example/main.h              Main program  header file
  - SysTick/SysTick_Example/system_stm32f30x.c  STM32F30x system source file
  
@note The "system_stm32f30x.c" is generated by an automatic clock configuration 
      system and can be easily customized to your own configuration. 
      To select different clock setup, use the "STM32F30x_Clock_Configuration_V1.0.0.xls" 
      provided with the AN4152 package available on <a href="http://www.st.com/internet/mcu/family/141.jsp">  ST Microcontrollers </a>
         
@par Hardware and Software environment

  - This example runs on STM32F303xC and STM32F303xE Devices.
  
  - This example has been tested with STMicroelectronics STM32303C-EVAL (STM32F30x)
    evaluation board and can be easily tailored to any other supported device 
    and development board.

  - STM32303C-EVAL Set-up
    - Use LED1, LED2, LED3 and LED4

          
@par How to use it ? 

In order to make the program work, you must do the following :
 - Copy all source files from this example folder to the template folder under
   Projects\STM32F30x_StdPeriph_Templates
 - Open your preferred toolchain
 - Add the following files to the project source list
   - Utilities\STM32_EVAL\STM32303C_EVAL\stm32303c_eval.c 
 - Rebuild all files and load your image into target memory
 - Run the example


 */
